"wiremold"

Connects 2000 Series Raceway to 1/2" trade size conduit or armored cable connectors. 1/2" trade size KOs located on end, sides, and bottom of fitting. Includes ground screw. If more capacity is required, use 2010A3. Black

Category: Plugmold End Fittings

Two-compartment Pole. Nominal Material Thickness .040" (1.0mm). Gray Boot Base.furnished Unwired Without Outlets. Mounting Hardware, Entrance End Plate And Ceiling Trim Plates Furnished. Length: 15' 5" (3.8m). Rs Adapt To Yourcurrent Or Future Work Environments.

Category: Steel Power Poles

For installation of two-gang devices or two vertically mounted single-gang devices on undivided raceway. Use with industry standard double-gang faceplates for electrical and communication devices. Can also be used with 4000B Series. Certified to Canadian Safety Standards for sale in Canada. When ordering these products, change the "V" color prefix to "CV" or the "G" color prefix to "CG" to denote the Canadian versions. Gray

Category: 2-Gang Raceway Device Brackets & Plates

Poke-Thru Device, Flush, Assembled Unit, Non-Metallic Cover, Color: Black. Diameter: 8-1/4". Depth: 9-1/16". Includes: Duplex Receptacle (20 Amp, 125 Volt, NEMA 5-20R, 2P, 3W, Straight Blade), (1) Ortronics TracJack Mounting Bezel & (1) Ortronics Series I, 4 Outlets and Provisions for 4 Data Jacks, Fits 4" Cored Hole

Category: Assembled Poke-Through Units

WIREMOLD EFB8-MB

Category: Recessed Floor Box Service Fittings

Steel, Prewired Plugmold, Tamper-Resistant, 3' Long, White, (6) Outlets, GFISteel, Prewired Plugmold, Tamper-Resistant, Length: 3 ft. Color: White. Outlets (6") O/C: Total Outlets: (6) GFCI, 15A, 125V: Single Circuit, Single Outlets. Built-in GFI Breaker.

Category: Single Circuit Tamper Proof Plugmold

Designed especially for use in the installation of signal system and alarm wiring. Base has 1/2" trade size KOs. Larger gang boxes available by special order. Single-gang: 4 5/8" L x 2 7/8" W (117mm x 73mm). Accepts NEMA single-gang standard faceplates. NOTE: Certified to Canadian Safety Standards for sale in Canada. When ordering these products, change the "V" color prefix to "vc" or the "WH" color suffix to "WHC" to denote the Canadian versions. White

Category: 1-Gang Raceway Device Boxes

Floor Box, 6 Gang, Evolution Series, 4.130 x 13.750 x 16.130 Inch, 915.980 Cubic Inches, Aluminum, Includes Protective/Disposable Cover, Tunnel System For Connecting Two Modules, (2) Removable Modules, (2) Toggle Clamps, (2) Cable Management Guides, (2) Levelling Support Legs, (2) "L" Brackets, and Knockouts Ranging from 3/4 - 2 Inch

Category: Square Recessed Floor Boxes

Available in 5' (1.5m) length with 9" spacing. 15A tamper-resistant receptacles. 3-wire, #12 THHN (1 hot, 1 neutral and insulated ground conductor). .040" (1.0 mm) steel housing. Packed two per carton. Each unit supplied with one (1) Coupling and two (2) Blank End Fittings. USB is 2.4 Amps (shared between two ports) 5VDC. Please note the charging load on one module will not affect the charging performance of the other USB modules in the product. Black

Category: Single Circuit Tamper Proof Plugmold

For power or communication devices in a single compartment. For use with 5507 Series Faceplates, Ortronics TracJack and Series II Modules, Pass and Seymour Activate Series Inserts, and Wiremold Open System Communication Modules. NOTE: CM-EPLA End Plates are required when using Wiremold communication modules and Pass and Seymour Activate inserts. S2-EPL End Plates are required when using Orthonics Series II Inserts. To mount TracJack inserts, use 5507-4TJ or 5507-6TJ Faceplates. White

Category: 1-Gang Raceway Device Brackets & Plates

Wiremold 4000 Series Raceway Base, Gray, Steel, 10' Length, Order of 10 Feet = 1 Piece Raceway, Gray, Two 9/32" (7.1mm) diameter KOs on centers of approximately 18" (457mm) throughout. No KOs on 1 1/4" (32mm) from each end, Oder of 10 Feet = 1 Piece Raceway

Category: Large 2-Piece Metallic Raceway Bases

Non-Metallic, 2-Gang, Device Bracket, 5400 Series. Size: 6" Length, 5-5/32" Width. PVC, Ivory.

Category: 2-Gang Raceway Device Brackets & Plates

Non-Metallic, Divided Entrance End Cap, 5400 Series. SIze: 7-1/2" Length, 7-1/8" Height, 3-1/2" Width. PVC, Ivory.

Category: 2-Piece Non-Metallic Raceway End Fittings

Non-Metallic, (2) Compartment Base, 5400 Series. Size: 8' Length, 5-1/4" Width, 1-11/16" Depth. PVC, Ivory.

Category: 2-Piece Non-Metallic Raceway

Non-Metallic, Full Width Cover, 5400 Series. Size: 8' Length, 4-31/32" Width. PVC, Ivory.

Category: 2-Piece Non-Metallic Raceway Covers

Steel, Coupling, 3000 Series. Size: 2-1/4". Galvanized Steel, Galvanized, Unpainted

Category: Small 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Steel, Coupling, 2000 Series. Size: 2" Length.

Category: Small 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Feeds 2000 Series Raceway from an existing wall outlet. Equipped with 1/2 trade size threaded stud, toothed lock washer for grounding, and conduit bushing. Gray

Category: Small 2-Piece Metallic Raceway Connectors & Adapters

Non-Metallic, Blank End Fitting, 5400 Series. Size: 5-15/32" Length, 1-25/32" Width. Includes: (4) 1/2" Trade Size KOs. PVC, Ivory.

Category: 2-Piece Non-Metallic Raceway End Fittings

1-Gang, Floor Box Cover, OmniBox Series, Metallic, Cover Type: Flip Lid, Device Type: Duplex Receptacle, Dimensions: 3-5/16" x 4-5/16", Material/Finish: Aluminum.

Category: Square / Rectangle Recessed Box Covers

WMD CRFB-KEY CRFB KEY KIT

Category: Recessed Floor Box Tools

Replacement Blade for 607 Cutter

Category: Raceway Tools

Raceway Cutter, Portable.

Category: Raceway Tools

WMD XBLNT LOCKNUT TOOL

Category: Rectangular Non-Metallic Underground Pull Boxes