"wiremold"

GFI Cover Plate, 3-1/4 x 4-5/32 Inch, Flip Lid, Aluminum/Brass Powder-Coat

Category: Square / Rectangle Recessed Box Covers

For connection of equipment grounding conductor to provide additional ground to raceway.

Category: Large 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Six outlets, putty white aluminum housing, 15A, lighted switch. 6' (1.8m) 14/3 SJT putty white cord with NEMA5-15 plug. Length 12 1/4" (311mm). Receptacle center-to-center 1 1/4" (32mm). Snap-on, slide-off mounting.

Category: General Duty Power Strips

Two-Compartment Extender Mounts onto Existing 25DTP or 25DTC Series Pole, Nominal Material Thickness: 0.04" (1.0mm), Furnished Unwired without Outlets, Use Existing Pole Mounting Hardware, Entrance End Plate and Ceiling Trim Plate, Available in 5' (1.524m) Length, Can Be Cut to Desired Length, Finish - Ivory

Category: Steel Power Poles

For mounting one or two keystone device modules, recessed to provide a flush installation. Has one opening and one KO. White

Category: 1-Gang Raceway Box Covers & Faceplates

Closes off open end of S4000 Base. Use when end feeds are required for an installation. Includes two 1/2" - 3/4" trade size KOs and two No. 10-32 ground terminals.

Category: Large 2-Piece Metallic Raceway End Fittings

Designed especially for use in the installation of signal system and alarm wiring. Base has 1/2" trade size KOs. Larger gang boxes available by special order. Three-gang: 4 5/8" L x 6 1/2" W (117mm x 165mm). NOTE: Certified to Canadian Safety Standards for sale in Canada. When ordering these products, change the "V" color prefix to "vc" or the "WH" color suffix to "WHC" to denote the Canadian versions.

Category: 3-Gang Raceway Device Boxes

Device plate for 8in and 10in poke thru units that will accept either decorator, GFCI, 106 style devices for power and audio/video applications. Finish - Designer Ivory

Category: Square / Rectangle Recessed Box Flanges

Communication bracket with four (4) RJ opening knockouts. Use as blank plate or for up to four RJ openings. Opening dimension is 9/16" x 3/4" (14.3mm x 19.1mm). NOTE: For use with RFB4-CI-1 only.

Category: Recessed Floor Box Service Fittings

Hub allows 2" conduit to be fed into the back of EFB6S and EFB6S-OG Floor Boxes. Maximum of six (6) hubs per box.

Category: Recessed Floor Box / Thru-Wall Seals

RADIANT FPC USB A/C 6FT WH

Category: Tamper Resistant Receptacle / USB Combination Devices

Combination Carpet and Tile Flange, 2-Gang, Powder-Coated Aluminum, Aluminum

Category: Square / Rectangle Recessed Box Flanges

WMD RFBA4R25OG RFBA 4G 2.5 IN

Category: Recessed Compartment Boxes

WMD EFB45CTCAA EVO FLR BX SUR

Category: Square Recessed Floor Boxes

Device Box, For 2000, V500, V700 Series Two-Piece Raceways, Single Gang, Switch or Receptacle, 1-3/4 In Deep, Steel, Gray, 1/2 In KO on Base

Category: 1-Gang Raceway Switch & Receptacle Boxes

Aluminum, Cover, AL Series. Size: 5' Length. Aluminum.

Category: Small 2-Piece Metallic Raceway Covers

Tele-Power Pole, Blank, Steel, Vertical, 2 Compartment, NO OUTLETS, Ivory.

Category: Steel Power Poles

Cover Plate, Powder-Coated Aluminum, 3/4" Plugs, Color: Black

Category: Square / Rectangle Recessed Box Covers

Non-Metallic, Device Bracket, 5000 Series. Size: 3-11/16" Length, 2" Width, 1-1/8" Height. PVC, Ivory.

Category: 1-Gang Raceway Device Brackets & Plates

W-mold G4086a Ivory Panel Conn

Category: Large 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Poke-Thru Device, 10 Inch Diameter, Recessed Prewired Assembly With Surface Style Cover, Includes: (2) 20 Amp Duplex Receptacles, (2) 68DB Device Brackets, (2) 10PTHA Outer Pass-Through Plates, (4) 1PTHA Center Pass-Through Plates, (1) 10BLH Outer Blank Plate, (1) 1075CHA Service Feed Plate, Aluminum Cover With Gray Finish

Category: Recessed Floor Box Service Fittings

W-mold 30tp-j Tele-pwr Pole C over

Category: Power Pole Covers

Non-Metallic, 2-Gang, Extra Deep Device Box, 2300BACD Series. Size: 4-3/4" Length, 4-7/8" Width, 2-3/4" Depth. PVC, White.

Category: 2-Gang Raceway Device Boxes

1.40" (35.40mm) Installs commercially available straight blade and locking single receptacle with face diameters of 1.38" - 1.39" (36mm - 37mm).

Category: Large 2-Piece Metallic Raceway Cover Plates