"wiremold"

Steel, Prewired Plugmold, Length: 5 ft. Color: Ivory. Outlets (12") O/C: Total Outlets: (5) 15A, 125V: Dual Circuit, Single Outlets

Category: Dual Circuit Steel Plugmold

Steel, Prewired Plugmold, Length: 6 ft. Color: Ivory. Outlets (18") O/C: Total Outlets: (4) 15A, 125V: Dual Circuit, Single Outlets.

Category: Dual Circuit Steel Plugmold

Table Box, Single Flip-Up Unit, Includes one (1) 15 Amp Black Tamper-Resistant Duplex Receptacle With (2) USB ports that provide 3.100 Amps. Black Powder Coat Finish

Category: Square / Rectangle Recessed Box Flanges

2800 Series Wire Clips. Holds and secures wiring and cabling inside raceway. Mounts with adhesive backing. Finish - Ivory

Category: 1-Piece Non-Metallic Raceway Clips & Couplings

Two-Gang Device Box û Cover has twistouts for 2000, 500, and 700 Series Raceway. Base has 1/2" trade size KO and rectangular KO for extension to wall box. Base has #10 threaded hole for ground connection. Finish: white enamel finish.

Category: 2-Gang Raceway Device Boxes

Combination Box, 3-Compartment, Metallic, Depth: 5 Inch, Length: 8-3/4 Inch, Width: 6-3/4 Inch. Raised Floorbox, Series AF, Color: Black Carpet Cover & Trim.

Category: Recessed Compartment Boxes

Non-Metallic, Prewired Plugmold, Length: 6 ft. Color: Ivory. Outlets (18") O/C: Total Outlets: (4) 15A, 125V: Single Circuit, Duplex Outlets.

Category: Single Circuit Non-Metallic Plugmold

Device plate that will accept up to two (2) Extron Electronics MAAP device plates. For use in either of the two side compartments only. Not for use in the center compartment. Extron devices supplied by others.

Category: Poke-Through Mounting Plates

Device plate that will accept up four (4) Ortronics Series II dual modular inserts. For use in the center compartment only. Devices supplied by others.

Category: Recessed Compartment Box Device Plates

Powder-coated aluminum power or communication plate, with 2" [51mm] and 3/4" [19.1mm] plugs. NOTE: Acceptable for use with threaded conduit when passing through power cables.

Category: Square / Rectangle Recessed Box Covers

Floor Box Assembly, Round, Type: 15 Amp Quad Receptacle, Diameter: 4 Inch, (3) 1/2 Inch Knockouts, Material/Finish: Aluminum/Aluminum, For Use in Raised Floor or Wood Floor Applications.

Category: Assembled Recessed Round Boxes

Surface Style Cover with Floor Insert, Flange, Tamper-Resistant, Material/Finish: Die Cast Aluminum/Black

Category: Square / Rectangle Recessed Box Covers

Surface Style Cover with Floor Insert, Flange, Tamper-Resistant, Material/Finish: Die Cast Aluminum/Black

Category: Square / Rectangle Recessed Box Covers

Seam Clip Fitting, DS4000 Series, Steel, White, Covers Seam Where Two Sections of DS4000C Come Together.

Category: Small 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Steel, Wall Box Connector, 4000 Series. Size: 12" Length. Includes: (2) 1/2", 3/4", 1", 1-1/4" Trade Size KOs, (2) 2-9/16"x1-11/16" Rectangular KOs. Gray.

Category: Large 2-Piece Metallic Raceway Clips, Connectors, & Couplings

For right angle turns around external corners. Integral dividers provide 2" (51mm) cable bend radius for UTP and Fiber Optic installations. Use the 5418FO for radiused alternative to 5418.

Category: 2-Piece Non-Metallic Raceway Elbows

For 90 degree tee connection at any point along a run of 6000 Series Raceway. Finish - Ivory

Category: Large 2-Piece Metallic Raceway Clips, Connectors, & Couplings

8" Round Cover Assembly, Evolution Series, Metallic, Cover Type: Tamper-Resistant Flush, Material/Finish: Die-Cast Aluminum/Gray Powder-Coat.

Category: Poke-Through Cover Assemblies

<p>Dual-service fitting includes housing, base, two mounting frames, divider, and mounting hardware. For use on one No. 2 and one No. 4 Duct. Has 1/2'' and 3/4'' trade size conduit knockouts on each end. 104.3 cu. in. (1709cm3) capacity.</p>

Category: Recessed Floor Box Service Fittings

Raceway Back Feed Fitting, 2400 Series, Steel, White, 1/2" Trade Size Male Bushing and Lock Nut Washer for Grounding

Category: Small 2-Piece Metallic Raceway Clips, Connectors, & Couplings

.040" (1.0mm) stainless steel. S4000C-5 is available in 5' (1.5m) lengths, packed ten 5' (1.5m) lengths per carton. Also available in lengths precut to customer specifications. (Max. 5' (1.5m) lengths.)

Category: Large 2-Piece Metallic Raceway Covers

Open Architecture Device Mounting Bracket and Trim Ring. Finish - Ivory

PN3 Series One-piece latching raceway with co-extruded hinge and adhesive bakcing. Available in 10' (3.0m) lengths. Finish - Fog White

Category: 1-Piece Non-Metallic Raceway

Connects equipment grounding conductor to provide an additional ground to raceway.

Category: Large 2-Piece Metallic Raceway Clips, Connectors, & Couplings